As you might imagine, with less than four months to go before the first of two big weddings, I find myself knee deep in projects. Please don’t read this as a complaint because I am loving every minute of it. It simply means that, instead of working on new quilt patterns and tutorials to share with you, I am taking this time to share some of the many small projects that are happening here at “Wedding Central” (as my husband refers to it.)
We are chipping away at the list one day at a time. However, it seems that just as soon as I cross one item off the list, another one magically appears. How does this happen?
Yesterday I made a bow tie for the little ring bearer. It is so darn cute and super easy that I thought it would be fun to share my process with a tutorial. Perhaps you would like to make one for a special little guy in your life?
1. Using a 1/4″ seam allowance, sew the two 2-1/2″ x 12-1/2″ pieces of main fabric and interfacing together, leaving approximately 2″ open for turning. (Note: ignore those diagonal lines printed on the interfacing.) With right sides together, fold both the neckband and loop pieces in half lengthwise and stitch 1/4″ away from the raw edges, as shown.
2. Turn the bow piece right side facing out and carefully use a tool or pencil to gently push the corners to a point. Hand stitch the opening closed. Press firmly. Also turn both the neckband and loop pieces right sides facing out, and press.
3. Getting the hardware in the right position on the neckband was a bit tricky for me at first so I will try to make this as clear as possible. Run first the “slider” and then the “eye” onto one end of the neckband, as shown.
4. Next, fold the end (shown on the left side above) to the backside and run it through the center bar of the slider. Turn and finger press approximately 1/2″ of the raw, short end of the neckband onto the backside to secure. It should look like this:
8. Position the completed neckband onto the wrong side of the bow, pin to secure. Then run the loop around the center point of the bow, covering the wrapped threads. Turn under the raw edges and hand stitch to secure.
Note: I did not stitch through to the neckband during this step. However, the neckband will slide and you may want to tack it in place once you have determined the exact needed size for your little guy.
With a few modifications, I think this design would also work well as a headband for a sweet little girl . . . just a thought! Friday I’ll share my easy mitered corner napkins. Then stay tuned as the next project will be robes for the bridesmaids. I just purchased this lovely new fabric from Verna Mosquera’s Rosewater line for Free Spirit Fabrics. I’m getting my serger tuned up and ready to roll. This will be fun!
Thanks for letting me share this special time with you. As always, sending you my best and hoping you are finding time to fill your souls with creative projects.